Image 1 of 1
Image 1 of 1
Image 1 of 1
Image 1 of 1
This is an STL file for you to 3d print yourself! This is a replacment of the OEM driver side accessory button slot on the 2015+ Subaru WRX’s to allow a cable of your choosing through.
Fitment is only confirmed on the 2020 WRX but I believe it is the same from 2015+
—To remove the OEM placeholder is a bit of a pain but not to hard.—
The insert has small clips that click into the accessory panel—two on top and one on the bottom. To remove the OEM insert, use two thin tools: wedge one at the top and one at the bottom, then push the front of the insert inward while wiggling until it slides out. It's tight, so be patient. The 3D-printed insert fits securely but can be pushed out.
This is an STL file for you to 3d print yourself! This is a replacment of the OEM driver side accessory button slot on the 2015+ Subaru WRX’s to allow a cable of your choosing through.
Fitment is only confirmed on the 2020 WRX but I believe it is the same from 2015+
—To remove the OEM placeholder is a bit of a pain but not to hard.—
The insert has small clips that click into the accessory panel—two on top and one on the bottom. To remove the OEM insert, use two thin tools: wedge one at the top and one at the bottom, then push the front of the insert inward while wiggling until it slides out. It's tight, so be patient. The 3D-printed insert fits securely but can be pushed out.