This is a replacement for the OEM accessory button in 2015+ Subaru WRX’s to allow a cable of through while maintaining a factory look.
Fitment is only confirmed on the 2020 WRX but should fit 2015 and up.
—To remove the OEM placeholder—
There are small detents on the insert itself that click in on that accessory panel. There are 2 on top and 1 on the bottom when looking at it from behind. The best way to get the OEM insert out is to get 2 thin pieces of something and wedge one on top and one on the bottom and the push from the front of the insert inward and maybe wiggle until it slides out. Its tight so take your time. Once its out the 3d printed one sits snug but will push back out if need be.
This is a replacement for the OEM accessory button in 2015+ Subaru WRX’s to allow a cable of through while maintaining a factory look.
Fitment is only confirmed on the 2020 WRX but should fit 2015 and up.
—To remove the OEM placeholder—
There are small detents on the insert itself that click in on that accessory panel. There are 2 on top and 1 on the bottom when looking at it from behind. The best way to get the OEM insert out is to get 2 thin pieces of something and wedge one on top and one on the bottom and the push from the front of the insert inward and maybe wiggle until it slides out. Its tight so take your time. Once its out the 3d printed one sits snug but will push back out if need be.
